Skip header
 

Using RICOH Smart Device Connector through wireless direct connection

To use the Wireless Direct function on an MFP/printer with Smart Operation Panel, it is also necessary to configure the following settings:

1Log in as the machine administrator from the Smart Operation Panel.

2Open the [Screen Features] screen.

  • Models with the [Home] key

    1. Press the [Home] key.

    2. Flick the screen to the left or right, and then press [Screen Features].

  • Models without the [Home] key

    1. Press [Home] (Operation panel screen illustration) at the bottom of the screen in the center.

    2. Flick the screen to the left or right, and then press [User Tools].

    3. Press [Screen Features].

3Press [Wireless Direct Settings].

4Select [ON].

5Set wireless connection mode to Group Owner Mode.

Specify whether to enable or disable this mode. To connect from a smart device, enter the SSID and password.

6Return to the [Wireless Direct Settings] screen.

7Press [Port Forwarding to Machine].

8Press [Port Forwarding Settings].

9Check that [Port Forwarding] is active.

10Log out.