G700 FAQs - By Product

[Question] How to set / authenticate a password (camera lock - Barcode)

Password is used to set the [Password Protection] function, or to change or release the limit for camera operations.
The password setting is located in the Setup menu.
[About the Setup menu operations.]

Use the following procedure for setting and authentication with barcode.

[Choose/Change password]

  • 1Go to Setup menu, then choose [Choose/Change Password].
  • Setup menu > Choose/Change Password

  • 2Choose [Barcode] in the screen below, and click [OK].
  • Choose [Barcode] to click OK.

  • 3[Read Barcode] screen is displayed.
  • Read Barcode screen
    Like the figure above, point the camera to make the barcode into the blue frame. Press the [MENU/OK] button.
    If you want to cancel it, press the [DISP.] button.

  • 4The camera reads the barcode. After succeeding the password reading, the password has been set. It returns to the menu screen.
    If barcode reading fails; such as the camera cannot focus on the barcode, or the barcode is out of the blue frame; the message like below will be displayed.
  • Password reading fails.
    Choose [Yes] and press the [MENU/OK] button. It returns to the [Read Barcode] screen, then try again with the step 3.

[Supported Bar Codes]
  • Linear bar codes: EAN-13/8, UPC-A/E, UPC/EAN (with add-ons), Interleaved 2 of 5, CODEBAR (NW-7), CODE 39, CODE 93, CODE 128, TYPE C, GS1-128 (EAN-128), and RSS (GS1 DataBar)
  • 2nd Dementional bar cords: QR Code, Micro QR Code, DataMatrix (ECC200), PDF417, Micro PDF 417, MaxiCode, EAN-UCC Composite (GS1 DataBar Composite)

Example of supported barcodes.

Example of supported barcodes.

[Password authentication]

  • 1You will be asked when the password authentication is required.
  • Password authentication
    Point the camera to make the barcode into the blue frame. Press the [MENU/OK] button.

  • 2If the authentication fails, you will be asked again as follows.
  • If the authentication fails:
    Choose [Yes] and press the [MENU/OK] button. It returns to the [Read Barcode] authentication, then point the camera to make the configured barcode into the blue frame, then press the [MENU/OK] button.

The timing when the barcode password is required varies depending on the selected option in the password protection.
[How to set a limit to camera usage (camera lock).]
 
Answer ID:g07102
Date created:September 24, 2010
Date modified:September 28, 2010
Product:G700
Operating system: --
Category:Hardware specifications, Hardware operations
Was this information helpful ?

Solved my problem
Somewhat Helpful
Followed the advice, but did not help
This FAQ was not relevant

Did you visit the FAQ before or after the purchase ?

Before
After

Please send us your feedback on this FAQ.


In order to protect your privacy, do not include any personal information. The feedback will not be encrypted during transmission. If you would like to have a reply, please contact us here.
Useful LINKs:

Do you need other information? Please click any link you want from the following.

Page Top