The following instructions will guide you through the process of updating your camera's
firmware.
1. Confirm the version of the camera's current firmware
| |
Please check the version of the camera's current firmware
before beginning this update.
|
| |
1. |
Turn the mode dial to SETUP. |
| |
2. |
While pressing both the down arrow button and the telephoto button, turn the power
on. |
| |
3. |
A table like the one below will be displayed on the monitor. If "V 1.00" (or a lower number) is
displayed in the CPU2 field, you will need to update your camera's firmware to the most recent version. |
| |
|
CPU1: V X.XX
CPU2: V 1.00
MON: V X.XX
ADJ: V X.XX
SH: XXXXXX
ST: XXXXXX |
|
|
| |
Note: This screen
will be displayed for about 20 seconds. You will not be able to turn the power off or use any of the other
functions during this time. Please wait until this display finishes, at which point the SETUP screen will be
displayed. |
|
2. Preparations
| |
In order to complete this firmware update, you
will need:
|
| |
1. |
The Caplio G4wide digital camera |
| |
2. |
The AC-4a AC adapter or fully charged batteries |
| |
3. |
An SD memory card to store the files on (this update cannot be
performed using the camera's internal memory) |
| |
|
You might also need software (like
WinZip
or
PKZIP
) that will "unzip" the
downloaded file and extract its contents.
After these preparations are complete, you are ready to update your camera's firmware. |
|
3. Update procedure
| |
1. |
Exit RICOH Gate L, then connect the camera to the computer
via the USB cable. |
| |
2. |
Click on the
FirmUpdate.exe
file, then follow the on-screen instructions
to complete the update. |
|
|
|
|
