The following instructions will guide you through the process of updating your camera's
firmware.
1. Confirm the version of the camera's current firmware
| |
Please check the version of the camera's current firmware
before beginning this update.
|
| |
1. |
Turn the mode dial to SETUP. |
| |
2. |
While pressing both the down arrow button and the telephoto button, turn the power
on. |
| |
3. |
A table like the one below will be displayed on the monitor. If "V 1.00" (or a lower number) is
displayed in the CPU2 field, you will need to update your camera's firmware to the most recent version.
|
| |
|
CPU1: V X.XX
CPU2: V 1.00
MON: V X.XX
ADJ: V X.XX
SH: XXXXXX
ST: XXXXXX |
|
|
| |
Note: This screen will be displayed for about 20 seconds. Please wait until this display finishes, at which point the SETUP screen will be displayed. |
|
2. Preparations
| |
In order to complete this firmware update, you
will need:
|
| |
1. |
The Caplio GX8 digital camera |
| |
2. |
The AC-4a AC adapter or fully charged batteries |
| |
3. |
An SD memory card to store the files on (this update cannot be
performed using the camera's internal memory) |
| |
|
You might also need software (like
WinZip
or
PKZIP
) that will "unzip" the
downloaded file and extract its contents.
After these preparations are complete, you are ready to update your camera's firmware. |
|
3. Update procedure
| |
1. |
Exit RICOH Gate L, then connect the camera to the computer
via the USB cable. |
| |
2. |
Click on the
FirmUpdate.exe
file, then follow the on-screen instructions
to complete the update. |
|
|
|
|
